Dashboard Warning Lights: Which Mean Stop Now and Which Can Wait
A warning light is your car asking for attention, and the colour tells you how urgently. A few red lights mean you should stop as soon as it is safe, because driving on can destroy the engine or your brakes. Most amber lights mean book a check soon. Here is how to tell them apart.
Contents
Key points
- Red usually means stop as soon as it is safe. Amber or yellow means check soon. Green or blue lights are information only.
- Stop driving for low oil pressure, high engine temperature, a red brake warning or a charging warning.
- A steady check-engine light means book a diagnosis soon. A flashing one usually means a serious misfire: slow down and get the car checked straight away.
- Symbols vary between makers. Your owner's manual has the exact meaning for your car.
What the colours mean
Most manufacturers use a traffic-light system:
| Colour | Meaning | What to do |
|---|---|---|
| Red | A serious fault or a safety issue | Stop as soon as it is safe, switch off and investigate |
| Amber or yellow | A fault or a system that needs attention | Drive carefully and have it checked soon |
| Green or blue | A system is on, such as headlights, high beam or cruise control | Nothing; information only |
When you start the car, most lights come on briefly as a bulb check, then go out. A light that stays on, or comes on while driving, is the one to act on.
Stop as soon as it is safe
These warnings mean that driving on could cause serious damage within minutes, or that the car may not be safe.
| Warning | What it usually means | What to do |
|---|---|---|
| Oil pressure (red oil can) | The engine has lost oil pressure | Stop and switch off immediately. Check the oil level when the engine has cooled. Do not restart if the light returns. |
| Engine temperature (red thermometer) | The engine is overheating | Stop and switch off. Do not open the coolant cap while hot. Look for leaks and check the coolant level once cool. |
| Brake system (red BRAKE or circle with "!") | Parking brake on, low brake fluid or a brake hydraulic fault | Check the parking brake is fully released. If the light stays on, do not drive; brakes may fail. |
| Charging system (red battery) | The battery is not being charged, often a failed alternator or broken drive belt | Switch off non-essential electrics and drive directly to a safe place or workshop. The car will stop when the battery runs flat. |
| Flashing check-engine light | A severe engine misfire | Reduce speed and load, and get the car checked straight away. Unburnt fuel can overheat and damage the catalytic converter. |
| Power steering (red, on some cars) | Steering assistance has failed | Steering will be very heavy. Stop safely and seek help. |
An oil pressure light comes on during a highway drive. Pulling over at the next safe place and finding the oil level very low costs the price of a few quarts of oil and, perhaps, a leak repair. Driving another 20 miles to get home can seize the engine, which on many cars costs more to replace than the car is worth.
Check soon
| Warning | What it usually means | What to do |
|---|---|---|
| Steady check-engine light | The engine management system has stored a fault | Have the code read within days. A loose fuel cap is a common, harmless cause; tighten it and see if the light clears after a few trips. |
| Tyre pressure (horseshoe with "!") | One or more tyres is significantly under-inflated, or the monitoring system has a fault | Check and inflate all tyres when cold, using the pressures on the driver's door frame. If a tyre keeps losing air, get it repaired. A flashing light usually means a system fault. |
| ABS | The anti-lock system has a fault | Normal brakes usually work, without anti-lock assistance. Drive carefully and book a check. |
| Airbag or SRS | The airbag system has a fault and may not deploy in a crash | Book a check promptly. This is a safety system. |
| Traction or stability control | Flashing: the system is working on a slippery road. Steady: it is switched off or has a fault | If steady and you have not switched it off, book a check. |
| Glow plug (diesels) | Coil symbol: wait before starting. Flashing while driving: engine fault | Wait for it to go out before starting. If it flashes while driving, have it checked. |
| Low fuel, washer fluid or service reminder | Routine reminders | Refill or book the service. |
Electric and hybrid cars
Electric and hybrid cars add their own warnings, such as a high-voltage system fault, a battery temperature warning or a "reduced power" mode. Treat a red high-voltage or battery warning as a stop-now warning, and never attempt repairs to the orange high-voltage cables yourself. Your manual explains each symbol; a reduced-power warning usually means drive gently to a safe place and contact the manufacturer's roadside service.
Getting a check-engine code read
The check-engine light is controlled by the car's on-board diagnostics system, which stores a fault code such as P0301 (a misfire in cylinder 1). You have three options:
- A parts store, many of which read codes free of charge.
- Your own scanner. A basic OBD-II reader plugs into the port under the dashboard and costs less than one workshop diagnosis.
- A workshop diagnosis. A code tells you where the fault is detected, not always what has failed. A good technician will test before replacing parts.
A code is a starting point. "Replace the oxygen sensor" is not a diagnosis on its own; ask what test confirmed it.
Keep a note
When a light comes on, note the date, the mileage, the weather and what you were doing, such as cold start, accelerating or braking. Intermittent faults are much easier to find with that information, and it saves diagnosis time you would otherwise pay for.
Sources and further reading
- Your vehicle's owner's manual, which has a page explaining every warning light on your dashboard.
- The National Highway Traffic Safety Administration's guidance on tyre pressure monitoring systems and vehicle safety at nhtsa.gov.
- The US EPA's information on the on-board diagnostics (OBD-II) system that controls the check-engine light.
Common questions
Why did a warning light come on and then go off?
Some faults are intermittent, and some systems switch the light off once a self-test passes. The fault is usually stored in the car's computer, so a workshop can still read it. Note when it happened and what you were doing.
Can I clear the check-engine light myself?
An inexpensive OBD-II scanner can read and clear codes, and many parts stores will read them free. Clearing the light does not fix the fault, and the car may fail an emissions inspection if the readiness checks have been reset.
Is it safe to drive with the ABS light on?
Usually your normal brakes still work, but without anti-lock assistance in an emergency stop. Drive gently, leave extra distance and get it checked soon. If the red brake warning is also on, stop.
Why are all my lights on at once?
Several warnings appearing together, especially with dimming lights or electrical problems, often point to the charging system or a weak battery. Get it checked before the car stops.
This guide is general information, not a substitute for a qualified mechanic. Warning light symbols and meanings vary by manufacturer; always follow your owner's manual. If you are unsure whether a car is safe to drive, do not drive it.
Stay ahead of the warnings
Most warning lights are caused by wear that a regular service would catch. See what is due on your car with our maintenance checker.
Open the maintenance checkerRead next
Car careCar Batteries: Warning Signs, Testing, Jump-Starting Safely and Replacement
How long batteries last, the warning signs, how to test one with a multimeter, how to jump-start safely and what to buy.
Car careCar Maintenance Schedule: What Is Due and When, With a Mileage Checker
Typical service intervals by mileage and time, what counts as severe use, and a checker that lists what is due on your car.
OwnershipCommon Car Problems New Owners Face, and How to Spot Them Early
The faults that catch new owners out, the warning signs and what each one usually costs to ignore.